Set up input and output routing
On SETUP > Configure > Routing > Camera, Media and Object routing we set the input routing for:
and the output routing for:
For SDI signals (AJA and BMD) this means recreating the physical routing.
Set up input routing
Set the Genlock source for each machine:
Genlock is used to synchronize the camera and tracking data to provide guaranteed video output timing
External ref - Genlock comes from an analog external ref signal. Both Blackburst and Tri-level syncs are supported
External SDI(n) - Genlock is derived from a specified SDI input’s video clock
Freerun - an internal Genlock is generated - this does not guarantee synchronisation with other machines.
There should be one common source for the Genlock signal
Add all camera systems and media inputs to the respective machines
Optionally enable Body Pose Estimation - Learn more about how to Set up Body Pose Estimation (BPE)
Set their Input sources
Add all object trackers whose tracking should be available on a specific machine
Only one camera system can be added per machine.
Set up output routing
Add outputs for each machine
Set their output destinations
Route 2 or more media outputs to the machine
In case one of the channels is a key, choose "Key" in VideoI/O > Video output > Output type
Add 2 output channels by clicking the + icon on "Video Outputs"
Choose the channels you want to output
Set the "Output Number" to which output this channel should be mapped
Check the Utilities tab for their indices (Index order from the top down)
Composited Output Number: 0 → Media Output 01 index: 0
Composited Key Output Number: 1 → Media Output 01 - Key index: 1
The frame rate of inputs and outputs must be the same!
For example, if your production needs to output in 50p, choose a 50p output format and set your physical camera and the camera system in SETUP > Configure > Video I/O up to match.
Review incoming tracking data routing
The incoming tracking data routing is done on the individual camera systems and object tracker groups. On SETUP > Configure > Routing > Incoming tracking data routing you can then review it.
Review the assigned tracking services
For camera systems: Use the tracking service the camera system will be routed to
For object tracker groups: Use the tracking service most of the object trackers will be routed to
Check the IP addresses and port number of the assigned tracking services on your camera and object tracking system
Send the tracking data to one of the listed network adapters and its specified port
For the Ncam system, the IP address and port number should be entered in the Advanced section of the camera tracking protocol
Check the status field
Your tracking configuration is set up correctly if it shows incoming data
You can also show logs or check the Network status in the Editor